Designed for removing those odd annoying thistles that appear when you don't have a grubber. With the addition of this stainless steel cutter to the heel of the boot, the thistle can be cut off cleanly at ground level. The boot is swung much the same way as you would swing a grubber.

Also helps with the removal of boots. Hook the cutter under a step or onto a piece of wood and pull your foot out of the boots.

Disclaimer:-
Jenquip cannot be liable for any damage caused to people or other property by this product during use or at any other time. Use of the product, fitting it and suitability of boots is solely the users responsibility. Jenquip makes no guarantee of merchantability or fitness for purpose.

Fitting instructions:-
The thistle cutter should be fitted to the boots which is most natural to use for grubbing thistles. However one can be fitted to each boots to assist with boot removal.

1. Select boots to fit cutter to. Read following instructions and ensure heel of boot is large enough to mount the cutter on before cutting the heel. 
Hollow heels may not be suitable

2. Hold boot upside down in vice or similar. Place cutter "squarely" across heel so that it spans full width without protruding. Draw a line across heel.

3. Draw lines down both sides of heel from existing line 16 millimeters. Join these lines together around the back of the heel keeping the line parallel with the seam in the boot. If this line cuts through the seam or comes too close to it, the boot maybe not be suitable for this purpose. Using a hacksaw or sharp knife, cut away the heel up the drawn lines.

4.Position the cutter in place and ensure it fits snuggly. Remove more heel if required. Use a 3/32" (2.5mm) drill, drill two pilot holes into the heel using the holes in the cutter as a guide. Drill approx 1" (25mm) deep.

5. Apply instant adhesive (elephant glue) to the vertical cut face of the heel (don't get it on your hands!) Position the cutter and screw it in place with the two screws supplied. A cordless screwdriver is recommended for this.

Maintenance:-
The cutter may need sharpening occasionally. Sharpen sufficiently but not too sharp. This is dangerous and the cutting edge would also be easily damaged on stones etc.

Here is an easy way to lift your bike off the ground for servicing or just cleaning! It is designed for two-wheel motorbikes.

Adjustable for different heights. It has a non-slip support and removable handle. Various designs are available.

Specifications:-

A custom job consulting on requirements, renovating second hand parts, building some new parts, installation and commissioning.